AggAuto Universal 40"x13" Car Grill Mesh - 100x33cm Aluminum Alloy Automotive Grille Insert Bumper 6x12mm Rhombic Hole, One of the Most Multifunctional Shape Grids Black

Nice selection of mesh colors and sizes. Easy enough to custom fit with strong snips. We used this to cover openings in the RV under the stove and sink and it works well. It did take a long time to ship but we knew that when we ordered it. Recommend.

Quality is good, Easy to cut. I little difficult to unwind. I need to placed it under a piece of wood to flatten it out. Overall good. I bought a second one already.

Excellent. Perfect solution to protect the condenser / radiator on the cars with big grille openings. Had to get one of the smallest size zip ties available (1.8mm wide) to tie horizontally on the 4 x 8 rhombus one. 2 thumbs up!

Easy to work with. Pretty sturdy. Just have to be handy and resourceful when it comes to application. The only down side is the coating/paint already started chipping after the first day of driving. Not necessarily a problem as long as it does the job protecting the inside from rock/debris. Huge difference with the temperature also. Better airflow.

Very nice, stiff protective screening for my radiator, oil cooler and air conditioning cooler. People on the Santa Cruz forum were complaining that when a rock hit any of the above it was a $1,800 replacement cost that was not covered under warranty. So at the recommendation of others I got 2 sheets of this in the 4x8 rhombic size. I didn't install it like others, zip tying it either on the outside or the inside of the grill like so many others. I'm not doing that to $40,000 new car! I watched a YouTube video on how to take the front end with installed grills off my car. being very careful it took me 45 minutes and the whole front end was laying on the grass in front of the car. It was then very easy, with regular scissors, to cut the screening to fit the back side of the grill. I left tabs on the screen where I saw screws on the back side that held grill in place. I then back the screws out one by one and screed them back in first through the screen tab then back in the hole holding the grill in place. That held the screening in place against the back of the grill. Start to finish, in my driveway, It took me 4 hours, which was well worth it, to get a factory looking job. The tools I used to do this were a small flathead screwdriver for the plastic pop fasteners, a 10 mm socket for the eight bolts, a pair of scissors for cutting the screen and a Phillips head screwdriver for attaching it to the existing screws holding the grill in place.I did have some concern when I finished because it looked so beautifully black with very little silver aluminum radiator showing, that maybe too much of the airflow would be blocked by the screening... I can tell you that this is absolutely NOT the case! We've had heat indexes over 105 degrees the last few days and I've driven the car around town, on the highway and sat in it parked on a blacktop parking lot with the air conditioning running for over an hour and the engine temperature gauge is exactly where it has always been, just a hair under mid-range. I have not seen the slightest change!

EXCELLENT

Should be obvious that this comes in a roll. What might not be Otis how difficult it is to make it flat.

It makes my truck look awesome and protects my radiator on my 2018 f250 diesel truck, i made little holes on the grill but it worked out perfectly