3 Inch Rear Lift Blocks for Tacoma, dynofit Rear Leveling Block Kit Compatible with 2005-2023 Toyota Tacoma, 1999-2021 Tundra, Suspension Lift Block Square Leaf Spring Ubolts Kit (Extended U-bolts)

I've had my truck for 5 years and the rear has always sagged and because I like girls, I needed to fix it. These were just what I needed. I have a heavy canopy on my bed so I needed the 3" blocks. Most people probably need the 2" for a first gen tundra (unless you haul tools and heavy stuff everywhere) be prepared with penetrating oil, a 2 foot breaker bar and a grinder with a cut off wheel. I had to loosen the nuts on my ubolts so I could cut the middle of the "U" and then rotate the halves so I didn't have to cut twice on each ubolt. Once I cut them, I rotated the halves and dropped the plate below the axle. I cleaned it up and used the new hardware that is nice and clean high grade hardware. Make sure you orient the blocks with the slightly thinner end towards the front of the truck. It's like that to compensate for the change in angle of the driveshaft. And use the German torque specifications of Goodentight. Retorque them to Goodentight again after a couple hundred miles or so. Take a before picture to show the difference between before and after. I forgot the before picture.

Todo quedó de acuerdo a lo planeado.

All you need

Came with everything needed to install and was a tapered block and gave intended lift