Zero Clearance Inserts For DeWalt 7491, 7491RS, 7490 (Type 1), 744, 745, 746, 7480, with Riving Knife Slot, Precise Cuts with No Tear-Out, Include Off-set Screws, Easy Height Adjustment, 4-Pack

Great quality and they fit perfectly.Since the Dewalt table saw doesn't have a steel top they can't use magnets for holding these down, and admittedly I'm probably worried about nothing since I used my first one with no issue but I simply put a piece of masking tape on one side to make a "forced fit" that helped my OCD.

I didn’t specify if it would fit the DWE 7492 model but i still bought them anyway. It was a little too tight lengthwise but it was an easy fix. I used my stock insert as a pattern and routed the excess. Fit perfectly and was an even better fit.

Zero clearance blanks.

These fit Dewalt 7491 perfectly. The only issue is there’s no lock.

I'm a bit disappointment the rivving knife doesn't work or fit when ripping something 1/4" or less... Outside of that they fit well

Works like a dream! Remove splitter, insert throat plate , turn on saw and raise blade. That’s it!

Nice fit at first. Now has become loose. Believe it to be from low humidity.Can not screw it down.Did provide nice clean cuts.I would buy again.

I only used one so far and it worked great. I did install one of the adjusting screws even though it didn't need adjusting but it stripped the hole out so I left them out.