Rainguard Water Sealers Concrete Sealer, Penetrating Protection Against Water and Salt Damage, For All Concrete Surfaces, Silane/Siloxane Waterproofer, Natural Finish, Ready to Use, 1 Gallon

Even more important than whether it protects, will it change the look of my pavers? Definitely not! I was concerned that my blocks would look shiny or darker than they did before I used the sealer. I was relieved to see that when the sealer dried, it was completely invisible, unnoticeable. I used the sealer just for the cap stones on my retaining wall and around my landscape beds. I also used it on my chimney cap. I did the chimney cap first and I used one of those cheap foam paint brushes. That was not the best way to apply it. The directions say to use a garden sprayer but I felt there would be too much overspray and I would run out of product. Instead, I used an empty spray bottle of kitchen cleaner. It was a little tiring with all that trigger pumping but I was able to lay down a nice even coat. I went over it a few times to make sure the stone was saturated pretty well. It is important to get that "second coat" on before the first one dries, overwise it will repel itself. After allowing a day for drying, I noticed as I was watering my landscaping that the water was beading off the caps pretty well. If there are few spots where it wasn't beading as well it is probably because I didn't saturate that spot enough. Bottom line: I am very happy with this sealer. My cap stone now sheds water instead of absorbing it and it look exactly the same as it did before the application. Using a hand sprayer worked great for my job but it would take forever to do an entire driveway that way!

Living up to its sealer name!! I applied this to concrete pavers and as you can see in my photos it beads up the water. This is as an invisible layer on top! Absolute shield!I park a van on top on these pavers. These are the perfect photos below it that are wet from a major storm. The rest of them are wet from the storm but it is not penetrating the concrete!To apply just use a quality sprayer and it goes on quick. I set a timer for one hour and hit it again quickly! It could go on most likely sooner as instructions say you can but recommend the hour. The color remained the same after I applied two coats on this grey and dark blend concrete paver. Buy this deal!!!

Worked as advertised, but I miscalculated how much I would need for two coats. Would buy this again.

Our concrete driveway is about 33 years old. Since we purchased the house 3 years ago, we have seen the driveway start to get some small cracks where it's in the sun all day so we decided to seal it. We pressure washed it the first day with water only, no cleaners, and let it dry. The next day we sprayed on 2 coats of this sealer, letting it dry about 3 hours between coats. Now when it rains, the water just beads up and runs in rivulets down to the street but it is not slippery to walk on when it's wet. It did an excellent job of sealing the concrete and we know our driveway is protected and will last for much longer than without it. It was a simple process and we'll repeat it every year or two as we feel it's needed.

this item is ok. goes on milky, dries clear. if you garage floor has moisture, this material will eventually flake. works fine for now

Followed instructions and put down 2 coats. The next day it rained heavy all day, and the surface stayed dry. Sealer was easy to apply and cleanup.

This rain guard sealer does appear to repel the water. I have not had a chance to see how it does will oil leaks yet I will purchase more to finish up my driveway. This was very easy to spray on and does not change the look or color of your driveway . In the picture, you can see where I applied it. This was after a rain.

Sealed my concrete walkway, used two applications. It's better to spread with squeegee, not just spraying on. Also, squeegee off the excess which is not absorbed into concrete. Repels water so far, after 3 months.